NTBA Member new to this site

[TEX-T]

Hi all. TEX-T here. I've been an NTBA memeber for about 3 years. Saw this site the other day and liked what I saw, so I signed up. I am about 70 percent finished with my T-Bucket. It has a 260 Olds V8. I saw a post on making some headers but can't find it now. I found some headers for an Olds Cutlass. I got them mainly for the flanges. I thought about cutting off the pipes an inch or so from the flange, but the they turn down like block hugger headers, so don't think that will work to well. I was trying to avoid having to make the square part of the pipe and welding to back side of flange and trying to grind the whole thing flat and true with a grinder.
Any ideas you all have would be welcome.
Thanks,
Tex-T

[Keeper]

Hello and welcome.

You will get tons of ideas but before that you will get tons of demands for pics

I think the post(how to) you are looking for is on the front page.

[Telman2]

Welcome to the forum Tex-T.

[san-i-T]

Hi and welcome to the forum !! Where are you from?

[Todd]

We are slipping! It must be Monday.

And as per the if you got a project you have to show pictures.
I wonder if the article you are looking for is in the tech section?

Welcome again!

[RocknT]

,,,,,,,,,,,,,

[TEX-T]

Originally Posted by san-i-T

Hi and welcome to the forum !! Where are you from?

Denison,Texas (up near Oklahoma border).

[TEX-T]

I'll have to figure out the picture thing. Don't have digital camera, so will have to scan photo's.

[butch27]

Don't feel bad about that . I have the camera and can't post very well. Oh and Welcome.

[bill4u6]

welme from somerset ky