Anyone with a ford C4 still up?
This is a discussion on Anyone with a ford C4 still up? within the Lounge forum, part of the T-Bucket Bar & Grill category.
I need to drill two holes in a plate I'm going to weld to the transmission crossmember and I can't ...
| |||||||
| Register a FREE Account! | Mark Forums Read |
|
#1
06-24-2008, 10:08 PM
| ||||
| ||||
| Anyone with a ford C4 still up? I need to drill two holes in a plate I'm going to weld to the transmission crossmember and I can't remember the correct width. It's the holes that the transmission mount lower studs fit through. I think its about 2 1/4" center to center but I'm not sure and I won't drill unless i'm sure. If any of you know or have a ford transmission to measure really quick, I would really appreciate it. Thanks.         |
| Sponsored Links |
I pray my love for these cars never fade
|
#3
06-24-2008, 11:28 PM
| ||||
| ||||
| Re: Anyone with a ford C4 still up? Thanks Thomas, but I will be able to measure the mount in the morning when I get off work at 6am. I'll just have to wait until then to drill the plate. There are better tools here at work than I have at home. |
 |
| Sponsored Links |
| |
« Previous Thread
|
Next Thread »
| Thread Tools | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2-1965 Ford Falcons | Rick | Lounge | 6 | 05-25-2008 04:12 PM |
| 41-48 Ford Brakes | LRS30 | Brakes | 4 | 03-11-2008 07:15 AM |
| New Ford V-6 &5 speed | old round fart | Engines and Drivelines | 0 | 02-08-2008 08:14 PM |
| Ford 9" | PaulR | Suspension | 3 | 02-05-2008 09:57 PM |
| Ford 460 BB in a T-frame | Joe Speno | Engines and Drivelines | 5 | 12-15-2007 08:47 PM |
| Sponsored Links |
All times are GMT -5. The time now is 08:50 AM.
