Attn: Twisted Minis.......Exhaust tubes
This is a discussion on Attn: Twisted Minis.......Exhaust tubes within the Lounge forum, part of the T-Bucket Bar & Grill category.
Great job on the form die for the exhaust tubes !
I did the same thing when I started to ...
| |||||||
| Register a FREE Account! | Mark Forums Read |
|
#1
10-09-2008, 11:53 PM
| ||||
| ||||
| Attn: Twisted Minis.......Exhaust tubes Great job on the form die for the exhaust tubes !  I did the same thing when I started to build the log intake for my old Caddy. I was building the whole manifold from Copper ( I had it available...$$$$). I used round copper tubing for the runners and had to form them reqtangle to match the intake ports. I'm sure your set up will work fine, nice going !  "BH"        |
| Sponsored Links |
|
#2
11-16-2008, 10:23 PM
| ||||
| ||||
| Re: Attn: Twisted Minis.......Exhaust tubes Thank you! Do you have any pictures of the copper manifold? It sounds interesting.
__________________ If you can find it cheaper, I can fix it! |
 |
| Sponsored Links |
| |
« Previous Thread
|
Next Thread »
| Thread Tools | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Press Forming Tube for Exhaust Flange | Twisted Minis | Shop Tools and Tricks | 9 | 10-18-2008 08:47 PM |
| exhaust coating | Mallard | Engines and Drivelines | 7 | 10-05-2008 11:22 AM |
| attn: T-odd | RPM | RPM | 5 | 09-29-2008 09:18 PM |
| ATTN: Lee in KC | RPM | Lounge | 11 | 08-21-2008 11:47 PM |
| Exhaust Valve for engine | Duke | Lounge | 4 | 03-08-2008 11:55 PM |
| Sponsored Links |
All times are GMT -5. The time now is 08:43 AM.
