Welding table
This is a discussion on Welding table within the Shop Tools and Tricks forum, part of the Technical Articles category.
This welding table was built almost entirely from the scrap yard. It has adjustable feet made from new 3/4" NF ...
| |||||||
| Register a FREE Account! | Mark Forums Read |
Published by Todd 08-07-2008 | |||||||||
| |||||||||
| | |||||||||
 | |||||||||
|
#1
By
Baby Huey
on
08-08-2008, 12:43 PM
|
| Re: Welding table I like it, I think it looks real good. I like the long arms on the sides to clamp to, good thinkin ! Good Job ! I have a side plate off of a Drum from an old Steam Donkey, It's got lots of big holes in it that come in handy to clamp to...... I bolted an old vice to it, helps hold small pieces.... "BH"  |
 |
 |
| Sponsored Links |
| |
« Previous Article
|
Next Article »
| Article Tools | |
| |
Similar Threads | ||||
| Article | Article Starter | Category | Comments | Last Post |
| welding header flanges | bill4u6 | Engines and Drivelines | 12 | 11-20-2008 01:11 PM |
| Let the welding begin | Temporary Insani-T | Frames and Chassis | 5 | 07-30-2008 06:04 AM |
| welding classes | jrn | Frames and Chassis | 13 | 05-04-2008 03:11 PM |
| Sponsored Links |
All times are GMT -5. The time now is 05:38 PM.
