Squaring it up
This is a discussion on Squaring it up within the Frames and Chassis forum, part of the Shop category.
here's an easy way. Measure from front center to each side of rear. Numbers should match to be square. Then ...
| |||||||
| Register a FREE Account! | Mark Forums Read |
|
#11
07-30-2008, 01:19 PM
| ||||
| ||||
| Re: Squaring it up here's an easy way. Measure from front center to each side of rear. Numbers should match to be square. Then the same rear to front. Doesn't matter when ya do it. But I'd definently do it before the first drive. Last edited by blownt; 07-30-2008 at 01:22 PM..         |
| Sponsored Links |
 |
| Sponsored Links |
| |
« Previous Thread
|
Next Thread »
| Thread Tools | |
| |
| Sponsored Links |
All times are GMT -5. The time now is 06:40 PM.
